Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:blender:repairing_mesh [2021/04/28 09:41] – murray | en:blender:repairing_mesh [2024/01/11 16:12] (current) – [Repairing a large hole] julia | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Repairing Mesh ===== | + | ===== Repair models |
- | ==== Patching | + | ==== Repairing |
- | {{:en: | + | {{en: |
- | Due to the resolution error of the medical scanner, a small structure | + | Due to the resolution error of the medical scanner, a small structure |
- | {{:en: | + | {{en: |
- | In edit mode, select the unnecessary | + | In edit mode, select the superfluous |
- | {{:en: | + | {{en: |
This creates a hole in the outer surface of the model. | This creates a hole in the outer surface of the model. | ||
- | {{:en: | + | {{en: |
- | To correct this, switch to edit mode (1) and ensure | + | To correct this, switch to edit mode (1) and make sure that edge selection is switched |
- | {{:en: | + | {{en: |
- | Then choose | + | Then select |
- | {{:en: | + | {{en: |
- | Press F to fill between the selected edges. This also works for small holes that appear | + | Press F to fill between the selected edges. This also works for small holes created |
- | {{:en: | + | {{en: |
- | {{:en: | + | It is also possible to select " |
+ | |||
+ | {{en: | ||
+ | |||
+ | Once the hole is closed, it is a good idea to select the now closed hole and repeat the " |