Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
en:blender:repairing_mesh [2024/01/11 16:09] – removed - external edit (Unknown date) 127.0.0.1 | en:blender:repairing_mesh [2024/01/11 16:12] (current) – [Repairing a large hole] julia | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ===== Repair models ===== | ||
+ | ==== Repairing a large hole ==== | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | Due to the resolution error of the medical scanner, a small structure was created that is not part of the actual model. The following shows how this can be removed. | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | In edit mode, select the superfluous vertices and press the Delete key on the keyboard. Select " | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | This creates a hole in the outer surface of the model. | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | To correct this, switch to edit mode (1) and make sure that edge selection is switched on (2). | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | Then select the edges around the open hole. | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | Press F to fill between the selected edges. This also works for small holes created during decimation and other operations. | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | It is also possible to select " | ||
+ | |||
+ | {{en: | ||
+ | |||
+ | Once the hole is closed, it is a good idea to select the now closed hole and repeat the " |