Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:blender:repairing_mesh [2021/04/28 09:41] – murrayen:blender:repairing_mesh [2024/01/11 16:12] (current) – [Repairing a large hole] julia
Line 1: Line 1:
-===== Repairing Mesh =====+===== Repair models =====
  
-==== Patching a Large Hole ====+==== Repairing a large hole ====
  
-{{:en:blender:repairing_mesh.png?800|}}+{{en:blender:repairing_mesh.png?direct&800|}}
  
-Due to the resolution error of the medical scanner, a small structure has been generated which is not part of the actual model. The following shows how to remove it.+Due to the resolution error of the medical scanner, a small structure was created that is not part of the actual model. The following shows how this can be removed.
  
-{{:en:blender:repairing_mesh_1.png?800|}}+{{en:blender:repairing_mesh_1.png?direct&800|}}
  
-In edit mode, select the unnecessary vertices and push delete on the keyboard. Choose "Vertices" from the list. Repeat until the desired vertices are all deleted.+In edit mode, select the superfluous vertices and press the Delete key on the keyboard. Select "Vertices" from the list. Repeat this process until all desired vertices have been deleted.
  
-{{:en:blender:repairing_mesh_2.png?800|}}+{{en:blender:repairing_mesh_2.png?direct&800|}}
  
 This creates a hole in the outer surface of the model. This creates a hole in the outer surface of the model.
  
-{{:en:blender:repairing_mesh_3.png?800|}}+{{en:blender:repairing_mesh_3.png?direct&800|}}
  
-To correct this, switch to edit mode (1) and ensure that edge selection is turned on (2).+To correct this, switch to edit mode (1) and make sure that edge selection is switched on (2).
  
-{{:en:blender:repairing_mesh_4.png?800|}}+{{en:blender:repairing_mesh_4.png?direct&800|}}
  
-Then choose the edges around the open hole.+Then select the edges around the open hole.
  
-{{:en:blender:repairing_mesh_5.png?800|}}+{{en:blender:repairing_mesh_5.png?direct&800|}}
  
-Press F to fill between the selected edges. This also works for small holes that appear during decimation and other operations.+Press F to fill between the selected edges. This also works for small holes created during decimation and other operations.
  
-{{:en:blender:repairing_mesh_6.png?800|}}+{{en:blender:repairing_mesh_6.png?direct&800|}}
  
-{{:en:blender:repairing_mesh_7.png?800|}}+It is also possible to select "Area" and then "Fill". The hole may then have to be filled piece by piece. 
 + 
 +{{en:blender:repairing_mesh_7.png?direct&800|}} 
 + 
 +Once the hole is closed, it is a good idea to select the now closed hole and repeat the "Smoothing" and "Beautifying" operations.